android – What exactly is txPower for Bluetooth LE and how is it used?

android – What exactly is txPower for Bluetooth LE and how is it used?

Most beacon formats contain a single byte in the transmission that indicates what the expected signal level should be when you are one meter away. This byte is sometimes called txPower (short for transmitted power) and sometimes measured power.

Do not confuse this with a second configuration setting on some beacon models that lets you vary how strongly the transmitter actually sends its broadcasts. This is typically called transmit power, which is why measured power is a less easily confused term.

The measured power field is used to make distance estimates. If the phone sees that its signal level is the same as the measured power field transmitted by the beacon, it knows it is exactly one meter away. If it has a stronger signal, it knows it is closer. If it has a weaker signal it knows it is further away. Using a formula, you can get a rough idea of the distance in meters.

Making this distance estimate accurate requires having the measured power field set properly to the expected signal level at one meter. It is often pre-configured into the beacon by the manufacturer, but it is typically adjustable. Why would you want to adjust it? If you place the beacon inside a cabinet, it might attenuate the signal. If you place the beacon against a metal wall, it might increase the signal due to reflections. For this reason, it is recommended that you calibrate a beacon by measuring and setting its measured power value after installation.

Calibration involves using a phone to measure the beacon signal level (using a measurement called the Received Signal Strength Indicator or RSSI, which is measured in dBm). To calibrate, you hold a phone with a typically performing bluetooth receiver (ideally an iPhone 6, but Nexus devices work well too) exactly one meter away from the beacon, and measure the average signal strength over 30 seconds. Many beacon configuration apps and tools like Locate for iOS and Android have calibration utilities.

Once you have the calibration value, you need to configure it inside your beacon per the manufacturers instructions. This will give you more accurate distance estimates.

Check that issue maybe it helps:
Get Tx Power of BLE Beacon in Android also you could check out some devBytes from Google about BLE

If you are using specific BLE beacons you need to referenced the datasheet and check how tx power is measured. As you already mentioned there is different definitions for it. During my dev I found that most suitable is that : txPower is measured in some distance from transmitter with way without obstacles. So if there is a wall for example txpower will be lower. Consider that.

android – What exactly is txPower for Bluetooth LE and how is it used?

txPower has defined the range of the Bluetooth signal to transmit the beacon.

Leave a Reply

Your email address will not be published.